MYTEK PROS / CONNECTED OPERATIONS
Power, Energy and Electrical Quality Monitoring
Make selected electrical loads visible.
Plan your project
01 / THE OPPORTUNITY
Understand where selected loads draw power.
Facilities, energy managers and industrial operations
A single utility bill cannot show which circuits are consuming energy or when electrical conditions change.
Plan appropriately installed voltage, current, power, and energy measurement, then use the data to investigate baseload, operating patterns, and power-quality exceptions.
- Identify high-use circuits
- Investigate after-hours consumption
- Support electrical maintenance reviews
APPLICATIONS IN PRACTICE
Electrical measurements in context.
Illustrative scenarios for facilities teams and operators.
A commercial building has unexplained baseload.
ObserveMeasure selected branch circuits with actual voltage and current inputs.
ActReview high-use circuits outside operating hours.
ReviewCircuit-level energy and after-hours consumption.
Separate tenant and essential loads before recommending changes.
A factory wants to review poor power factor.
ObserveCollect supported power-factor and harmonic metrics.
ActHave an electrical specialist investigate repeated exceptions.
ReviewElectrical-quality trend and exception duration.
Monitoring does not automatically correct power quality.
A multi-site operator evaluates a lighting change.
ObserveMeasure matched circuits before and after the change.
ActReview use alongside operating hours.
ReviewEnergy comparison with stated baseline and confounders.
Savings need a documented measurement method, not simple before/after arithmetic.
03 / FROM SIGNAL TO RESPONSE
From observation to action.
Define the signal, the connection and the person responsible for the next step.
View measurements & event details
- Voltage, current, power factor, active power and energy where supported
- Reactive/apparent quantities on supported power-monitor hardware
- THD and voltage unbalance only on the supported hub
A DEFINED SERVICE SCOPE
What Mytek Pros can help deliver.
Mytek Pros can plan circuit-level power and energy monitoring for San Diego and California projects, including qualified installation, metering checks and after-hours load reports. Supported hardware can add power-factor or harmonic trends for specialist review. Measurement capability, any tariff estimates, installation and support are confirmed during discovery.
Explore service planning for San Diego and California projects. Installation, handover and ongoing support are agreed during discovery for the selected equipment and site.
View planned service deliverables
- Circuit survey and qualified installation
- Metering configuration and polarity checks
- Tariff and operating-calendar setup if needed
- Energy and electrical-quality reporting
THE RECORD YOU KEEP
Your reporting scope.
A configured Mytek Pros service can turn the selected measurements into:
- Circuit energy and peak power trends
- After-hours load and tariff-based cost estimates
- Electrical-quality exception trends on supported hardware
Configurable project options; confirm scope during discovery.
04 / DISCOVERY & DESIGN
Before installation.
Confirm compatibility, placement and operating responsibilities for your site.
What we’ll work through
- Current-only sensors are not equivalent to measured voltage-and-power metering
- Do not promise revenue-grade billing or certified energy savings
- Installation must follow electrical safety procedures
- Electrical-quality readings are diagnostic inputs, not a guaranteed fault prediction
Tell Mytek Pros about your site, existing systems, and the decisions you want the data to support.
Review your circuits and measurement objectives ↗EXPLORE CONNECTED APPLICATIONS