MYTEK PROS / CONNECTED OPERATIONS
Lighting Control and Use Monitoring
Design lighting around the way a space is used.
Plan your project
01 / THE OPPORTUNITY
Match lighting plans to actual use.
Commercial properties, workplaces and hospitality operators
Lights can remain on in empty areas while rigid schedules inconvenience occupants.
Combine compatible circuit controls with schedules, presence signals, and local overrides, then review operation with the right level of energy measurement.
- Reduce avoidable on-time
- Improve consistency of lighting routines
- Make control actions visible
APPLICATIONS IN PRACTICE
Rooms, opening hours and corridors.
Illustrative scenarios for facilities teams and operators.
An office wants meeting-room lights to follow use.
ObserveCombine reliable presence with a compatible lighting circuit.
ActApply approved occupied and delayed-off rules with manual override.
ReviewLighting-on time versus observed use.
Still occupants and timeout behavior require testing.
A retailer wants consistent opening and closing scenes.
ObserveUse a scene panel and approved schedules.
ActCommand compatible circuits and review exceptions.
ReviewScene-command history and after-hours on-time.
Command success is not always independent proof that a lamp is illuminated.
A campus evaluates corridor lighting schedules.
ObserveCapture circuit operation and actual energy where available.
ActPilot a schedule while protecting required illumination.
ReviewMatched-period on-time and metered-energy comparison.
Do not disable required safety illumination.
03 / FROM SIGNAL TO RESPONSE
From observation to action.
Define the signal, the connection and the person responsible for the next step.
View measurements & event details
- Circuit command and supported state
- Presence or light status from separate sensors
- Power and energy only on measurement-capable variants
A DEFINED SERVICE SCOPE
What Mytek Pros can help deliver.
Mytek Pros can help San Diego and California property teams review circuit compatibility, configure approved lighting schedules and presence rules, and test local overrides. Reporting can compare lighting on-time with observed use; energy reporting requires suitable metered hardware. Electrical installation, integration and support scope are confirmed during discovery.
Explore service planning for San Diego and California projects. Installation, handover and ongoing support are agreed during discovery for the selected equipment and site.
View planned service deliverables
- Circuit and load compatibility review
- Schedule, scene and presence-rule setup
- Local override and fail-state testing
- Optional electrical measurement and BMS integration
THE RECORD YOU KEEP
Your reporting scope.
A configured Mytek Pros service can turn the selected measurements into:
- On-time by zone and operating period
- Occupied-versus-lighting-on comparison
- Measured energy where a suitable metered controller is used
Configurable project options; confirm scope during discovery.
04 / DISCOVERY & DESIGN
Before installation.
Confirm compatibility, placement and operating responsibilities for your site.
What we’ll work through
- Switching loads and local electrical requirements must be verified
- Dry-contact and powered-output variants differ
- Emergency and life-safety lighting must remain appropriately independent
- Savings require metered evidence and a baseline
Tell Mytek Pros about your site, existing systems, and the decisions you want the data to support.
Assess your lighting circuits and schedules ↗EXPLORE CONNECTED APPLICATIONS